NEC SigmaBlade B140a-T Guía de usuario descargar pdf (Pagina 54)

100

101

4-2 Configuring Your Server

Starting SETUP Utility

Powering on the CPU blade starts POST (Power On Self-Test) and displays its check results. If the

NEC logo is displayed, press Esc.

After a while, the following message appears at bottom left on the screen.

Pattern 1:

Press <F2> to enter SETUP

Pattern 2:

Press <F2> to enter SETUP or <F12> to Network

Pattern 3:

Press <F1> to resume, <F2> to enter Setup, <F12> to Network

* The message depending on the status of CPU blade.

Press F2 to start the SETUP utility and display its Main menu.

If you have previously set a password with the SETUP utility, the password entry screen appears.

Enter the password.

Enter password:[ ]

Up to three password entries will be accepted. If you fail to enter the password correctly for three

consecutive times, the CPU blade halts. (You can no longer proceed.) Power off the CPU Blade.

NOTE: The CPU blade is provided with two levels of password:

Supervisor and User. With the Supervisor password, you can view and

change all system parameters. With the User password, system

parameters available for viewing and changing are limited.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 375 376

Comentarios a estos manuales

Sin comentarios

NEC SigmaBlade B140a-T Guía de usuario Pagina 54

Comentarios a estos manuales

Relacionado con productos y manuales para Servidores NEC SigmaBlade B140a-T