NEC SigmaBlade B140a-T Guía de usuario descargar pdf (Pagina 169)

Installing the Operating System with Express Setup 5-33

Installing with the OEM-FD for Mass Storage Device

This section explains how to setup with the OEM-FD. You usually do not have to do as follows. If

your system has any Mass storage devices, you have to set as follows depending on your system.

The detailed information is provided by the manual of the Mass storage device.

Installation of Mass storage device not to be supported by Express Setup

If you would like to install or re-install the OS when the system has new mass storage device not to

be supported by NEC EXPRESSBUILDER, you have to set as follows.

1. Read the manual supplied with the mass storage device before setting the server.

2. If the mass storage device is RAID Controller, configure the RAID System before running

the NEC EXPRESSBUILDER.

3. Boot the system from NEC EXPRESSBUILDER DVD.

4. Select [Load the optional driver into the EXPRESSBUILDER] from the Top menu, click

[Next].

Setting the driver disk for the mass storage controller. Press the "Perform" button.

NOTE: By choosing this option, you can load the driver provided by

CD-ROM or floppy disk to proceed with the Express Setup.

5. Perform Express Setup with the following settings.

(a) When "Enter RAID settings" appears, check "Skip the logical drive creation".

(b) Select "Apply OEM-Disk for Mass storage device".

6. Copy the driver for the mass storage device in the Express Setup.

Insert the floppy disk attached the mass storage device into the floppy disk drive.

Continue the Express Setup, referring to messages displayed on the display.

1 2 ... 164 165 166 167 168 169 170 171 172 173 174 ... 375 376

Sin comentarios

NEC SigmaBlade B140a-T Guía de usuario Pagina 169