NEC SigmaBlade B140a-T Guía de usuario descargar pdf (Pagina 241)

Troubleshooting 8-45

 Is BIOS configuration correct?

→ When the CPU blade has PCI devices connected, make sure to set the PCI device

interrupt and others with the BIOS SETUP utility of the CPU blade. (Most PCI

devices generally do not require any change to the configuration, but some boards

do require specific settings. Refer to the manual that comes with the board for

details to make correct settings.

<Menus to check: [Advanced] – [PCI Device] – [PCI IRQ xx] x: PCI slot number,

[Advanced] – [PCI Configuration] – [PCI Slot 1 Option ROM]>

→ Some devices connected to the serial or USB port may require I/O port address or

operation mode settings. Refer to the manual that comes with the board for details

to make correct settings.

<Menu to check: [Advanced] – [Peripheral Configuration], [Server] – [Console

Redirection]>

The keyboard or mouse fails to operate:

 Is BIOS configuration correct?

→ The keyboard and mouse may be disabled with the BIOS SETUP utility of the

CPU blade. Check the settings with the BIOS SETUP utility.

<Menus to check: [Advanced] – [Peripheral Configuration], [Advanced] –

[NumLock]>

 Did you install drivers for keyboard and mouse?

→ Refer to the manual that comes with your OS to check that the keyboard and

mouse drivers are installed. (These drivers are installed along with the OS.) Some

OS's allow you to change the keyboard and mouse settings. Refer to manual that

comes with your OS to check that the keyboard and mouse settings are correct.

 Is the system used in the status that Windows Server 2003 and Linux are not started?

→ In the following states with the use of USB keyboard and USB floppy disk drive,

conduct key entries when the access lamp on the USB floppy disk drive is off (or

the floppy disk is not accessed).

–Press F6, S, and Enter in installation by using the Windows Setup Disk.

– Start of ROM-DOS Startup FD for command input

Fail to access the hard disk drive:

 Is the hard disk drive applicable to the CPU blade?

→ Operation of any device that is not authorized by NEC is not guaranteed.

 Is the hard disk drive properly installed?

→ Securely insert the drive carrier into the Blade Enclosure and lock it with the lever.

The hard disk drive is not connected to the internal connector when it is not

completely installed.

1 2 ... 236 237 238 239 240 241 242 243 244 245 246 ... 375 376

Sin comentarios

NEC SigmaBlade B140a-T Guía de usuario Pagina 241