NEC SigmaBlade B140a-T Guía de usuario descargar pdf (Pagina 164)

5-28 Installing the Operating System with Express Setup

4. Specify "Complete memory dump" and modify [Dump file:] in the [Write debugging

information] group box.

e.g. Write the debug information in D drive write the file name "MEMORY.DMP".

D:\MEMORY.DMP

5. Click [Settings] on the [Performance] group box.

The [Performance Options] window appears.

6. Click [Advanced] tab on the [Performance Options] window.

7. Click [Change] on the [Virtual memory] group box.

8. Modify [Initial Size] in the [Paging file size for selected drive] box to the value larger than

the value of [Recommended] in the [Total paging file size for all drives], and click [Set].

IMPORTANT:

 The above-mentioned paging file size is recommended for

collecting debug information (memory dump). The paging file

with initial size large enough to store the dump file in the boot

drive is required.

Correct debug information might not be able to be collected due to

virtual memory shortage when the paging file is insufficient, so set

an enough size of the paging file with the entire system.

 For more information on "Recommended" value, see "About the

System Partition Size" described earlier.

 In case the memory is expanded, re-specify the paging file to suit

the new memory size.

9. Click [OK].

The message to restart the system may appear according to the modified specification. In

such case, follow the message to restart the system.

1 2 ... 159 160 161 162 163 164 165 166 167 168 169 ... 375 376

Sin comentarios

NEC SigmaBlade B140a-T Guía de usuario Pagina 164