NEC SigmaBlade B140a-T Guía de usuario descargar pdf (Pagina 42)

2-18 General Description

Launch the BIOS SETUP utility when you need to change the settings to meet the

requirements for the CPU blade. As long as the above message is not displayed with an

error message, you don't have to launch the utility. (Ignore the message. POST will

automatically proceed.)

To launch the SETUP utility, press F2 while the above message is displayed. See Chapter

4 for setup and parameters.

The CPU blade automatically restarts POST all over again when you exit the SETUP

utility.

4. If the server has an optional board installed, POST displays the board information on the

screen.

Refer to the manual supplied with the board for details.

POST will automatically proceed a few seconds later.

5. If you have set the password using the BIOS SETUP utility, the password entry screen

appears upon successful completion of POST.

Up to three password entries will be accepted. Three incorrect password entries disable

the system to boot. In such a case, turn off the power and wait about 30 seconds before

turning on to boot the CPU blade.

IMPORTANT: Do not set a password before installing an OS.

6. The OS starts when POST completes.

POST Error Messages

When POST detects an error, it displays an error message on the screen. See Chapter 8 for POST

error codes.

IMPORTANT: Take a note on the messages displayed before

consulting with your service representative. Alarm messages are useful

information for maintenance.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 375 376

Sin comentarios

NEC SigmaBlade B140a-T Guía de usuario Pagina 42