NEC SigmaBlade B140a-T Guía de usuario descargar pdf (Pagina 291)

Upgrading Your Server 9-27

6. From top of the CPU unit, position the connector of the mezzanine card so that it aligns

the connector of the mezzanine card slot, and insert the mezzanine card straight into the

slot.

IMPORTANT:

 Do not make your body contact with the terminals on the board.

Some malfunction may occur if the board is installed with dirt

and/or oil adhering to the terminals.

 Insert the mezzanine card straight into the connector. The terminal

or connector may be damaged if it is inclined.

 If the board cannot be installed securely, remove the board once and

then install it again. Adding excess force to the board may cause the

board to be damaged.

7. Push the mezzanine card with fingers firmly toward the CPU unit to connect the card to

the slot.

8. Tighten the fixing screws to fix the mezzanine card to the spacer on the CPU unit.

9. Install the top cover having been removed.

10. Secure the top cover with five screws.

11. Install the CPU blade having been removed to the Blade Enclosure according to the User's

Guide of the Blade Enclosure.

12. Turn on the power of the CPU blade. Make sure that any error messages associated with

the board do not appear on the POST screen.

See Chapter 8 for details of POST error messages.

13. Select [Advanced] – [Reset Configuration Data] on the [Advanced] menu and set to [Yes].

This is required to update the hardware update information. See Chapter 4 for details.

14. Run the BIOS configuration utility of the installed board to provide setup for the board.

The existence of the utility and its start and operation procedures vary depending on the

type of the board. Refer to the documentation coming with the board for details.

Type I

Type II

1 2 ... 286 287 288 289 290 291 292 293 294 295 296 ... 375 376

Sin comentarios

NEC SigmaBlade B140a-T Guía de usuario Pagina 291