NEC SigmaBlade B140a-T Guía de usuario descargar pdf (Pagina 250)

8-54 Troubleshooting

Problems with NEC EXPRESSBUILDER

When the CPU blade is not booted from the NEC EXPRESSBUILDER DVD, check the following:

 Did you set the NEC EXPRESSBUILDER during POST and restart the CPU blade?

→ If you do not set the NEC EXPRESSBUILDER during POST and restart the

CPU blade, an error message will appear or the OS will boot.

 Is BIOS configuration correct?

→ The boot device order may be specified with the BIOS setup utility of the CPU

blade. Use the BIOS setup utility to change the boot device order to boot the

system from the optical disk drive first.

 If [Os installation ***default***] is selected at Boot selection menu, following

message is displayed.

After this message appears, check the error and take the appropriate corrective action

according to the message listed in the table below.

Message Cause

This EXPRESSBUILDER version was not

designed for this computer.

Insert the correct version and click [OK].

(When you click [OK], the computer reboots.)

This NEC EXPRESSBUILDER

version is not designed for this server.

Execute the NEC EXPRESSBUILDER

on the compliant server.

EXPRESSBUILDER could not get the

hardware parameters written in this

motherboard.

This version is not designed for this computer

or the motherboard may be broken. (When

you click [OK], the computer reboots.)

The hardware parameters written in this

motherboard are incorrect.

This version is not designed for this computer

or the motherboard may be broken.

This message is shown when NEC

EXPRESSBUILDER could not find

system-specific information because

of mother board exchange and so on.

1 2 ... 245 246 247 248 249 250 251 252 253 254 255 ... 375 376

Sin comentarios

NEC SigmaBlade B140a-T Guía de usuario Pagina 250