NEC SigmaBlade B140a-T Guía de usuario descargar pdf (Pagina 50)

3-6 Setting Up Your Server

In the ordinary operation, any cables may not be connected to a CPU blade. Proper cable(s) should

be connected to the USB, serial, and/or VGA ports on the CPU blade in the following cases:

 Installing OS (when the CPU blade is installed in Blade Enclosure (10U))

 Maintenance

 Updating BIOS and firmware

The separately priced K410-150(00) SUV cable can only be used to connect with the CPU blade.

(The K410-150(00) SUV cable is a standard accessory for the Blade Enclosure (SIGMABLADE-

H))

The 410-150(00) SUV cable has the USB, serial interface, and monitor connectors at the other ends.

Connect a proper device at each of the ends.

IMPORTANT:

 To connect a peripheral or interface cable provided by a vendor

other than NEC (or third party) to the CPU blade, make sure that the

device is available for the CPU blade. Some third party devices are

not available for the CPU blade.

 The serial port connector cannot be directly connected with the

leased line.

 Do not connect/disconnect the SUV cable or add/remove the USB

device until the operating system starts running.

To connect/disconnect the SUV cable or add/remove the USB

device after OS startup, follow restrictions of operating system.

If the device having serial interface is connected, first power off the

CPU blade and destination device, and remove the power cord from

the destination device before connecting/disconnecting SUV cable

or serial cable. Failure to follow it may cause the devices to be

defected due to the potential difference between them.

 If the CPU blade is installed in the Blade Enclosure and you are

going to install an OS in it, use the SUV cable. See the next page for

connection.

To CPU blade

To USB devices

To display unit

To serial interface device

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 375 376

Sin comentarios

NEC SigmaBlade B140a-T Guía de usuario Pagina 50