NEC SigmaBlade B140a-T Guía de usuario descargar pdf (Pagina 41)

General Description 2-17

POST Execution Flow

The following describes the progress of POST in the chronological order.

IMPORTANT:

 Do not make unnecessary key entries or perform mouse operations

while POST is in progress.

 Some system configurations may display the message "Press Any

Key" to prompt a key entry. This message is driven by BIOS of an

installed optional board. Make sure to read the manual that comes

with the optional board before any key entry.

 Powering on the server, after you installed or removed an optional

mezzanine card, may display the message that indicates incorrect

board configuration and suspend POST.

In such a case, press F1 to continue POST. Board configuration can

be made using the utility described later.

1. After a few seconds from power-on, POST starts checking the memory. The count

message of the basic and expansion memory appears on the screen of the display unit (if

connected). The memory check may takes a few minutes to complete depending on the

memory size of the CPU blade. Also, it may take approximately one minute for the screen

display to appear after rebooting the CPU blade.

2. Some messages appear upon completion of the memory check. These messages appear to

indicate that the system has detected the CPU and other devices installed.

3. After a few seconds, POST displays the following message prompting you to launch the

BIOS setup utility, SETUP, stored in the system memory of the CPU blade. This message

appears at bottom left on the screen.

Pattern 1:

Press <F2> to enter SETUP

Pattern 2:

Press <F2> to enter SETUP or <F12> to Network

Pattern 3:

Press <F1> to resume, <F2> to enter Setup, <F12> to Network

* The message depending on the status of CPU blade.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 375 376

Sin comentarios

NEC SigmaBlade B140a-T Guía de usuario Pagina 41