NEC Express5800/GT110d-S Guía de instalación descargar pdf (Pagina 78)

3. Setting Up Windows Server 2008 R2

Chapter 1 Installing Windows

3.8

Installation When Multiple Logical Drives Exist

Before starting reinstallation, backup data for future use in case of data loss.

(1) Installation process

 Setup with E

XPRESSBUILDER

Refer to Chapter 1 (3.2 Setup with EXPRESSBUILDER), and proceed with setup.

Important

The operating system will be installed on the first detected Hard Disk Drive or

logical disk drive.

 Setup with OS standard installer

1. Refer to Chapter 1 (3.3 Setup with OS Standard Installer), and start setup.

2. When the following message appears, select the partition to which you want to install the operating

system.

Select the location to which Windows will be installed

Important

 When you install a Windows system into an environment where multiple

Hard Disk Drives are connected, these drives are displayed as a

destination to install the system during setup.

At this time, the order and numbers of the disks displayed on the screen

might not match those of the Hard Disk Drives connected to the Hard Disk

Drive bay.

Distinguish between the Hard Disk Drives by viewing the Hard Disk Drive

capacity and partition size displayed on the screen, and then select a drive

to install the Windows system.

Selecting an improper drive might cause an unintentional corruption of the

existing data. Be careful when selecting a Hard Disk Drive on which to

install the system.

For details, refer to the following Microsoft website:

http://support.microsoft.com/kb/937251/en-us

 You cannot edit the drive letters for the system volume or boot volume

after setup is complete. Make sure that the drive letters assigned in this

window are correct, and then proceed with setup.

3. Refer to Chapter 1 (3.3 Setup with OS Standard Installer), and proceed to setup Windows with OS

standard instal

ler and the instructions.

The installation process is now complete.

Tips

The drive letter might change after installation. If you want to change the drive

letter, use the procedure shown in Changing drive letter assignments below.

Express5800/GT-110d, GT-110d-S, R110d-1E, E110d-1 Installation Guide (Windows)

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 277 278

Comentarios a estos manuales

Sin comentarios

NEC Express5800/GT110d-S Guía de instalación Pagina 78

Comentarios a estos manuales

Relacionado con productos y manuales para Software NEC Express5800/GT110d-S