NEC Express5800/GT110d-S Guía de instalación descargar pdf (Pagina 207)

6. Setting Up Windows Server 2003

Chapter 1 Installing Windows

(1) RAID settings

This function automatical

ly recognizes the RAID Controller connected to the server and configures the RAID

System, so you must complete setup of the server by following the "User’s Guide " in advance.

Important

Some data in the Hard Disk Drive might be deleted depending on the system

settings. Pay attention to input parameters. You must be especially careful

when configuring the following:

 RAID settings wizard

Backing up user data, as needed, is recommended.

Note

When using an onboard RAID Controller (LSI Embedded MegaRAID):

 This function does not support the creation of RAID10 by using the onboard

RAID Controller.

 Refer to Chapter 2 (4. RAID System Configuration) in "Maintenance Guide" when

creating RAID10.

Specify the RAID settings using the RAID settings wizard on the parameter setup menu.

Tips

Use the [Default] button when you want to return to the default value of parameters

after having modified them with the wizard.

You can confirm the value set by clicking the [Default] button if you click the

[Default values] button.

When creating a new Logical Drive

1. Click [Settings] in RAID settings.

2. Use the wizard to set up the Logical Drive.

When skipping the creation of a new Logical Drive

1. Click [Skip] in RAID settings.

Tips

Use the [Skip] button if, after modifying the settings with the RAID settings wizard,

you want to install the existing configurations without modifying them.

Express5800/GT-110d, GT-110d-S, R110d-1E, E110d-1 Installation Guide (Windows)

207

1 2 ... 202 203 204 205 206 207 208 209 210 211 212 ... 277 278

Sin comentarios

NEC Express5800/GT110d-S Guía de instalación Pagina 207