
3. Setting Up Windows Server 2008 R2
Chapter 1 Installing Windows
3.
Setting Up Windows Server 2008 R2
Set up Windows Server 2008 R2 and the system.
3.1
Before Starting Setup
Read through the cautions explained here before starting setup.
: Confirm during Setup with EXPRESSBUILDER
: Confirm during Setup with OS standard installer
(1/3)
Setup Items to confirm
Windows
family
The following editions of the Windows Server 2008 R2 family may be installed. For
information about Service Packs, refer to Chapter 1 (1.2 Service Pack Support).
Windows Server 2008 R2 Standard
Windows Server 2008 R2 Enterprise
Windows Server 2008 R2 Foundation*
* Only supported by GT110d-E and GT110d-S
Inquiries about installing other editions may be made at your sales dealer or
maintenance service company.
When installing Windows Server 2008 R2, the following hardware configurations
require special procedures.
Hardware
configuration
warnings
Reinstalling to a mirrored volume
When reinstalling to a Hard Disk Drive that has been converted to a dynamic disk,
the operating system can only be installed to a simple dynamic volume.
If installing to a mirrored volume by using Disk Management, disable mirroring
and return to a basic disk prior to installation. After the operating system is
installed, return to the mirrored state.
Click on Computer Management and then Disk Management to create, release,
or delete mirrored volumes
Connecting MO devices
Installing Windows while an MO device is connected can result in installation
failure. Remove the MO device, and then start installation from the beginning.
DAT, LTO, and similar media
Do not set media that is unnecessary to installation during setup.
RDX and similar peripheral devices
Depending on the configuration of the hardware being used, it may be necessary
to remove or stop peripheral devices prior to starting setup.
Refer to the manuals of each peripheral device to make sure each is in its
appropriate state, and then proceed with setup.
Reinstalling to Hard Disk Drives that have been upgraded to dynamic disks
If the Hard Disk Drive has been upgraded to a dynamic disk, an operating system
cannot be reinstalled to it with the existing partitions.
Set up the operating system with the OS standard installer.
Express5800/GT-110d, GT-110d-S, R110d-1E, E110d-1 Installation Guide (Windows)
17
Comentarios a estos manuales