NEC Express5800/GT110d-S Guía de instalación descargar pdf (Pagina 162)

5. Setting Up Windows Server 2003 R2 x64 Edition

Chapter 1 Installing Windows

7. If a RAID Controller or optional Controller is used, press the <F6> key while either of the following

messages is displayed.

"Setup is inspecting your computer's hardware configuration" (on the top of the screen)

"Press F6 if you need to install a third party SCSI or RAID driver…" (on the bottom of the screen)

Tips

 You do not have to press the <F6> key if no RAID Controller or optional

Controller is used. Go to step 14.

 Note that nothing changes on the screen even when the <F6> key is pressed.

 If the OEM drivers list is not displayed, check the boot order of the Flash FDD on

the BIOS setup window.

8. The following message appears.

When using a RAID Controller: Press the <S> key and go to step 9.

When not using a RAID Controller: Go to step 10.

9. Select one of the following from the driver list, and then press the <Enter> key.

 When using an onboard RAID Controller (LSI Embedded MegaRAID):

[LSI Embedded MegaRAID (Windows XP/2003 64-bit)]

 When using an N8103-129/130 RAID Controller:

[LSI MegaRAID SAS RAID Controller Driver (Server 2003 for x64)]

 When using an N8103-G128/128/134 RAID Controller:

[Promise SuperTrak EX Family Controller - 64bits platform]

The window shown in step 8 appears.

10. Check the connection status of other options.

When no optional Controller is used: Press the <Enter> key and go to step 14.

When N8103-107 is connected: Press the <S> key on the window in step 8, and go to step 11.

When no N8103-107 is connected: Go to step 12.

Express5800/GT-110d, GT-110d-S, R110d-1E, E110d-1 Installation Guide (Windows)

162

1 2 ... 157 158 159 160 161 162 163 164 165 166 167 ... 277 278

Sin comentarios

NEC Express5800/GT110d-S Guía de instalación Pagina 162