NEC Express5800/GT110d-S Guía de instalación descargar pdf (Pagina 204)

6. Setting Up Windows Server 2003

Chapter 1 Installing Windows

6.2.3

Setup procedure

This section describes the procedure for installing Windows Server 2003 using the OS standard installer.

Important

 Before starting setup, refer to 6.1 Before Starting Setup. It describes how

to make partitions.

 The procedure differs depending on the media on which

EXPRESSBUILDER is stored.

 The installation procedure depends on the environment. Check your

environment before starting installation.

1. Turn peripheral device power on, and then turn the server power on.

2. Use the following procedure to start EXPRESSBUILDER.

Note

Be sure to disconnect removable media before starting EXPRESSBUILDER.

When using the EXPRESSBUILDER DVD

(1) Insert the EXPRESSBUILDER DVD into the optical disk drive of the server.

(2) Once the DVD is inserted, restart the server by resetting it (press <Ctrl> + <Alt> + <Delete>) or by

turning the power off and then on again.

EXPRESSBUILDER starts.

When using Internal Flash Memory

(1) When "Press <F2> Setup, <F3> Internal Flash Memory, <F4> ROM Utility, <F12> Network"

appears below the POST screen, press the <F3> key.

EXPRESSBUILDER starts.

3. When the following message appears, select Os installation *** default ***.

You will automatically advance to step 4, with no need for further input.

Express5800/GT-110d, GT-110d-S, R110d-1E, E110d-1 Installation Guide (Windows)

204

1 2 ... 199 200 201 202 203 204 205 206 207 208 209 ... 277 278

Sin comentarios

NEC Express5800/GT110d-S Guía de instalación Pagina 204