NEC Express5800/GT110d-S Guía de instalación descargar pdf (Pagina 200)

6. Setting Up Windows Server 2003

Chapter 1 Installing Windows

(2/3)

Setup Items to confirm





Connecting to multiple Hard Disk Drives (Logical Drives)

For details on installing operating systems to a system in which multiple Logical

Drives exist, refer to Chapter 1 (6.8 Installation When Multiple Logical Drives

Exist).



Hardware

configuration

warnings

 Reinstallation to a dynamic disk:

When installing the OS on a Hard Disk Drive with multiple partitions that was

upgraded to a dynamic drive and you wish to retain the existing partition

configuration and data areas, note the following:

Normal (system)

Normal

Data area

(partition to be retained)

- Select the partition on which the OS was previously installed.

- Select Leave the current file system intact (no change) for the OS partition

format.



If Windows Server 2003 R2 is already installed, make sure that Windows Server

2003 R2 Edition DISC 2 has been installed before applying a Service Pack.



Use the Starter Pack when you apply a Service Pack from the Service Pack 2

CD-ROM.



Application of

Service Packs

If you used OS installation media including Service Pack 2 for installation, you do

not have to install Service Pack 2 again.

The system partition size can be calculated by using the following formula.

Size required to install the OS + paging file size + dump file size + application size

Size required to install the OS = 3,500 MB (Windows Server 2003 R2 with

Service Pack 2)

= 5,300 MB (Windows Server 2003 R2 + Service

Pack 2 CD-ROM)

= 5,300 MB (Windows Server 2003 with Service

Pack 1 + Service Pack 2 CD-ROM)

Paging file size (recommended) = installed memory size  1.5

Dump file size = installed memory size + 12 MB

Application size = as required by the application

For example, if the installed memory size is 1 GB (1,024 MB), the partition size is

calculated as follows:

3,500 MB + (1,024 MB  1.5) + 1,024 MB + 12 MB + application size = 6,072 MB

+ application size

Important

 The above paging file sizes are recommended for collecting debug

information (dump file). The initial size of the boot volume paging file

must be large enough to store dump files. Make sure you set a sufficient

paging file size. If the paging file is insufficient, there will be a virtual

memory shortage that may result in an inability to collect correct debug

information.

 The maximum paging file size that can be specified for one partition is

4095 MB. If 1.5 times of the mounted memory size exceeds 4095 MB,

specify 4095 MB.

 If the mounted memory size is 2 GB or greater, the maximum size of the

dump file is “2048 MB + 12 MB”.

 When installing other applications or other items, add the amount of

space needed by the application to the partition.



System

partition size

Express5800/GT-110d, GT-110d-S, R110d-1E, E110d-1 Installation Guide (Windows)

200

1 2 ... 195 196 197 198 199 200 201 202 203 204 205 ... 277 278

Comentarios a estos manuales

Sin comentarios

NEC Express5800/GT110d-S Guía de instalación Pagina 200

Comentarios a estos manuales

Relacionado con productos y manuales para Software NEC Express5800/GT110d-S