
3. Setting Up Windows Server 2008 R2
Chapter 1 Installing Windows
3.2
Setup with EXPRESSBUILDER
This section describes how to install Windows with EXPRESSBUILDER.
This function automatically recognizes the RAID Controller connected to the server and configures the RAID
System, so you must complete setup of the server by following the "User’s Guide " in advance.
Important
The Scalable Networking Pack (SNP) function is disabled on systems that
have been installed by using EXPRESSBUILDER.
The setting of SNP function may affect the system performance.
Contact the sales agent for details.
Setup with EXPRESSBUILDER may delete some data in the Hard Disk Drive
depending on the system settings. Pay attention to input parameters. You
must be especially careful when configuring the following:
RAID settings wizard
Partition Settings in the Windows Setup wizard
Backing up user data, as needed, is recommended.
Note
For a non-standard setup procedure without using EXPRESSBUILDER, refer to
the descriptions in Chapter 1 (1.4 When Using a Large-Capacity Storage Controller
Not Supported by EXPRESSBUILDER) or (3.8 Installation When Multiple Logical
Drives Exist).
Tips
Setup with EXPRESSBUILDER allows you to use a prespecified parameter file
or save the parameters specified in setup as a parameter file on a removable
media or Internal Flash Memory (if purchased optionally).
You can create a parameter file by using the Create a parameter file for
Windows OS function in EXPRESSBUILDER.
For details on creating a parameter file, refer to 8 Windows OS Parameter File.
Express5800/GT-110d, GT-110d-S, R110d-1E, E110d-1 Installation Guide (Windows)
20
Comentarios a estos manuales