NEC Express5800/GT110d-S Guía de instalación descargar pdf (Pagina 15)

1. Before Starting Setup

Chapter 1 Installing Windows

1.4

When Using a Large-Capacity Storage Controller Not

Supported by EXPRESSBUILDER

Use the following setup process when reinstalling an operating system to a system on which a large capacity

controller is connected that is not supported by EXPRESSBUILDER (such as the newest RAID Controllers).

1. When you are about to set up the system, have the manual for the large capacity storage controller ready.

Note

If the contents of this document differ from that of the large capacity storage

controller, prioritize the contents of the controller manual.

2. When using a RAID Controller, follow the controller manual to set up the RAID System.

If using a large capacity storage controller for which RAID setting is not required, go to step 3.

When you install using OS standard installer, refer to (setup with OS standard installer) section of each

OS.

Note

Click [Skip] in RAID settings.

3. Start the system from EXPRESSBUILDER.

4. Select Configure EXPRESSBUILDER settings from the top menu, and then select Load a driver into

EXPRESSBUILDER from the screen that appears. Next, click [Next].

Insert the media in which the driver for the large capacity storage controller is copied to the optical device

drive, select the destination, and then click [Perform].

Tips

By selecting this option, the driver supplied by the CD-ROM or floppy disk is

loaded, and you can proceed with the EXPRESSBUILDER setup.

5. Execute Setup with EXPRESSBUILDER by using the following procedure:

 Click [Skip] in RAID settings.

 Confirm that Apply drivers for mass storage controller appears under Selected applications in

Application settings.

Express5800/GT-110d, GT-110d-S, R110d-1E, E110d-1 Installation Guide (Windows)

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 277 278

Sin comentarios

NEC Express5800/GT110d-S Guía de instalación Pagina 15