NEC Express5800/GT110d-S Guía de instalación descargar pdf (Pagina 266)

8. Windows OS Parameter File

Chapter 1 Installing Windows

Important

 Some data in the Hard Disk Drive might be deleted depending on the

system settings. Pay attention to input parameters.

Backing up user data, as needed, is recommended.

 Partition size

 Specify a partition size larger than the minimum size required for

installing the operating system. (Refer to System partition size in Before

Starting Setup.)

 Do not specify a size that is greater than the capacity of the connected

Hard Disk Drive.

 If you select Create a new partition under Partitioning, the entire contents

of the Hard Disk Drive will be deleted.

 If you select Use the existing partition under Partitioning, data in the boot

partition (if it exists) and Windows partition is formatted and deleted. Data

in other partitions will be kept.

The figure below shows in which partitions data will be deleted.

Boot partition

Deleted

Windows partition

Deleted

User data partition

Retained

 You cannot reinstall the operating system in an existing partition that has

been upgraded to a Dynamic Disk (refer to Hardware configuration

warnings in Before Starting Setup). Do not select Use the existing partition

under Partitioning.

 The following message might be displayed when a created parameter file is

loaded. In this event, installation using an existing partition cannot be

executed. Select Create a new partition under Partitioning for installation. If

there is a data partition, it will be deleted.

Express5800/GT-110d, GT-110d-S, R110d-1E, E110d-1 Installation Guide (Windows)

266

1 2 ... 261 262 263 264 265 266 267 268 269 270 271 ... 277 278

Sin comentarios

NEC Express5800/GT110d-S Guía de instalación Pagina 266