NEC Express5800/GT110e-S Guía de instalación descargar pdf (Pagina 253)

7. Setup for Solving Problems

Express5800/GT-110e, GT-110e-S, R110e-1E Installation Guide (Windows)

253

Chapter 1 Installing Windows

8. For the Initial size text box in the Paging file size for selected drive group box, specify a value equal to

or greater than the Recommended value shown in the Total paging file size for all drives area, and

then click [Set].

Note the following when specifying a paging file size.

• The above paging file sizes are recommended for collecting debug information (dump file). The

initial size of the boot volume paging file must be large enough to store dump files. Make sure to

set a sufficient paging file size. If the paging file size is insufficient, correct debug information

might not be able to be collected due to a shortage of virtual memory.

• For details about the Recommended value in the Total paging file size for all drives area, refer

to System partition size in Before Starting Setup.

• When memory is added, re-specify the paging file according to the increased memory size.

9. Click [OK].

The message to restart the system appears depending on the modifications made. In this case, restart

the system.

Specification of the memory dump settings is now complete.

1 2 ... 248 249 250 251 252 253 254 255 256 257 258 ... 274 275

Sin comentarios

NEC Express5800/GT110e-S Guía de instalación Pagina 253