NEC Express5800/GT110e-S Guía de instalación descargar pdf (Pagina 137)

4. Setting Up Windows Server 2008

press5800/GT-110e, GT-110e-S, R110e-1E Installation Guide (Windows)

137

Chapter 1 Installing Windows

9. You can use the default setting for Probe interval and Probe maximum retries. If you change these

values, select a value from each drop-down list, click the target probe (Probe Target xx), and then click

[Edit Target IP Address…].

Tips

• The setting range of Probe interval (link packet transmission interval) is 1 to 60

(units: seconds).

• The setting range of Probe maximum retries (link packet retry count) is 1 to 10

(times).

• Switching a path upon detection of a communication path error by LiveLink

takes (Probe maximum retries + 1) x Probe interval (seconds) at maximum.

If a link is down is detected, failover occurs immediately after the link goes

down. It takes the time specified for Probe interval (seconds) to recover from the

link going down.

10. In the Target xx text box, enter the IP address of the alive monitoring server, and then click [OK].

Important

• Target xx must be the same broadcast domain as that specified for the data

communication IP and LiveLink communication IP (described in step 13).

Specify an IP address that exists on the network and with which

communication is possible.

• If communication with the IP address specified in Target xx is not possible,

the team will also be unable to communicate. It is therefore recommended

that you specify multiple IP addresses using Probe Target. Up to four IP

addresses can be specified.

1 2 ... 132 133 134 135 136 137 138 139 140 141 142 ... 274 275

Sin comentarios

NEC Express5800/GT110e-S Guía de instalación Pagina 137