NEC Express5800/GT110e-S Guía de instalación descargar pdf (Pagina 184)

5. Setting Up Windows Server 2003 R2 x64 Edition

Express5800/GT-110e, GT-110e-S, R110e-1E Installation Guide (Windows)

184

Chapter 1 Installing Windows

5.4.3

Setting up team/LiveLink

Important

• When using

Smart Load Balancing and Failover (without Standby

Member ), be sure to setup LiveLink at creation of team.

When using Smart Load Balancing and Failover (with Standby Member ),

setup for LiveLink is not essential.

• When deleting the team, refer to Chapter 1 (5.4.3 Setting up team/LiveLink)

- (4) Procedure for deleting team. When replacing the motherboard or a

LAN board, follow these steps to remove the team and create it again after

replacement.

• Be sure to specify the same Jumbo Mtu (Jumbo Packet) setting to all the

adapters that compose a team.

• Using Server Core installations, Not supporting setting up team/LiveLink

by the BACS.

(1) Team types

The following team types are supported.

• Smart Load Balancing and Failover (without Standby Member)

All adapters that compose the team perform communication.

If a communication failure occurs on an adapter, other adapters that compose the team continue the

communication.

When the adapter on which the communication failure occurred recovers, it joins the team again and

resumes the communication.

• Smart Load Balancing (Auto-Failback Disable) (with Standby Member)

Among the adapters that compose the team, primary adapters except the standby member perform

communication.

If a communication failure occurs, the standby member continues the communication.

When the adapter on which the communication failure occurred recovers, it joints the team again and

the standby adapter returns to the standby state.

(2) LiveLink

LiveLink is a function that detects communication route failures of adapters.

It periodically investigates the communication status of specified destinations (IP address).

Link packets are sent from each adapter within a team.

If a response to the transmission of a link packet within the specified range is not detected, it is identified as a

communication route failure and adapter communication is stopped.

When a response to the submission of a link packet is detected, communication LiveLink identifies

communication as having been recovered, and communication using that adapter automatically resumes.

Note

You must set up LiveLink when you create a team.

1 2 ... 179 180 181 182 183 184 185 186 187 188 189 ... 274 275

Comentarios a estos manuales

Sin comentarios

NEC Express5800/GT110e-S Guía de instalación Pagina 184

Comentarios a estos manuales

Relacionado con productos y manuales para Software NEC Express5800/GT110e-S