
5. Setting Up Windows Server 2003 R2 x64 Edition
Express5800/GT-110e, GT-110e-S, R110e-1E Installation Guide (Windows)
Chapter 1 Installing Windows
5.4
Setting Up Device Drivers
Install and set up device drivers provided for the standard configuration.
For details regarding the installation and setup of an optional device driver, refer to the manual supplied with
the optional device.
5.4.1
Installing the LAN and BACS (teaming) drivers
(1) LAN and BACS drivers
If the OS standard installer is used for setup, install Starter Pack to install the LAN and BACS driver.
Important
WOL is supported by the standard network adapters only.
Note
• To change the LAN or BACS driver settings, log on to the system from a local
console using an administrator's account. Remotely changing the settings by
using the operating system’s remote desktop feature is not supported.
• Be sure to select the Internet Protocol (TCP/IP) check box when specifying an
IP address.
(2) Optional LAN board
This server supports the following optional LAN boards.
The drivers for LAN boards are automatically installed using the OS plug-and-play function.
Optional LAN boards: N8104-132/133/138
Important Using an optional LAN board, perform procedure "5.4.2 Setting up LAN
drivers" for each optional LAN board.
If [! Ethernet Controller] is displayed in Device Manager after LAN boards has been installed, you need to
install the driver in the following procedure.
1. Set EXPRESSBUILDER DVD in optical disk drive.
When the Autorun menu appears, close the window.
Tips
If you apply Starter Pack from the internal flash memory, you do not need to set
EXPRESSBUILDER DVD.
2. Launch Device Manager, and double-click [! Ethernet Controller].
The [Ethernet Controller Properties] appears.
3. Click [Update Driver] in [Driver] tab.
[Hardware Update Wizard] appears.
4. Select [No, do not connect now.], and click [Next].
5. Select [Install from a list or specific location], and click [Next].
Comentarios a estos manuales