NEC Express5800/GT110e-S Guía de instalación descargar pdf (Pagina 18)

1. Before Starting Setup

Express5800/GT-110e, GT-110e-S, R110e-1E Installation Guide (Windows)

Chapter 1 Installing Windows

1.5

When Using a Mass Storage Controller Not Supported by

EXPRESSBUILDER

To install the Windows when using a mass storage controller not supported by EXPRESSBUILDER (such as

the newest RAID controller), follow the steps below.

You do not need to perform the following instructions usually.

1. Have the instructions for the mass storage controller ready.

Note

If the contents of this document differ from that of the mass storage controller,

prioritize the contents of the controller ’s document.

2. If you use a RAID controller, follow the controller instructions to configure the RAID system.

3. If you want to set up by using EXPRESSBUILDER, go to Step 4.

Refer to (Setup with OS standard installer) section of each OS and click [Skip] in RAID settings.

4. Boot from EXPRESSBUILDER.

5. Select Configure EXPRESSBUILDER settings from Top Menu, and then select Load a driver into

EXPRESSBUILDER. Next, click [Next].

Insert the media in which the driver for the mass storage controller is copied, select the destination, and

then click [Perform].

Tips

By selecting this option, the driver supplied by the CD-ROM or removable media is

loaded, and you can proceed with the EXPRESSBUILDER setup.

6. Setup the server according to "Setup with EXPRESSBUILDER" for each OS.

− Click [Skip] in RAID settings.

− Confirm that Apply drivers for mass storage controller appears under Selected applications in

Application settings.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 274 275

Sin comentarios

NEC Express5800/GT110e-S Guía de instalación Pagina 18