NEC Express5800/GT110e-S Guía de instalación descargar pdf (Pagina 165)

5. Setting Up Windows Server 2003 R2 x64 Edition

Express5800/GT-110e, GT-110e-S, R110e-1E Installation Guide (Windows)

165

Chapter 1 Installing Windows

20. If a RAID controller or an optional mass storage controller is used, press <F6> key while either of the

following messages is displayed. If not, go to step 25 without pressing <F6> key.

"Setup is inspecting your computer's hardware configuration" (on the top of the screen)

"Press F6 if you need to install a third party SCSI or RAID driver…" (on the bottom of the screen)

Tips

• Note that nothing changes on the screen even when <F6> key is pressed.

• If the OEM drivers list is not displayed at step 22, 24, check the boot order of the

Flash FDD on BIOS settings.

21. The following message appears.

If a RAID controller is used on the server, press <S> key and go to step 22.

If not, go to step 23.

22. Select the following from the driver list, and then press <Enter> key.

When using N8103-128 RAID Controller:

Promise SuperTrak EX Family Controller - 64bits platform

When using N8103-149/150/151 RAID Controller:

LSI MegaRAID SAS RAID Controller Driver

When using Onboard RAID Controller (LSI Embedded MegaRAID):

LSI Embedded MegaRAID (Windows 2003 64-bit)

The screen shown in step 21 appears again. Go to step 23.

23. If N8103-104A is connected, press <S> key and go to step 24.

If not, press <Enter> key and go to step 25.

24. Select LSI Fusion-MPT SAS Driver (Server 2003 x64), and then press <Enter> key.

The screen shown in step 21 appears again. Press <Enter> key and go to step 25.

1 2 ... 160 161 162 163 164 165 166 167 168 169 170 ... 274 275

Sin comentarios

NEC Express5800/GT110e-S Guía de instalación Pagina 165