NEC Express5800/GT110e-S Guía de instalación descargar pdf (Pagina 249)

7. Setup for Solving Problems

Express5800/GT-110e, GT-110e-S, R110e-1E Installation Guide (Windows)

249

Chapter 1 Installing Windows

7. Click [Settings] under Performance.

The Performance Options dialog box appears.

8. Click the Advanced tab on the Performance Options dialog box.

9. Click [Change] under Virtual memory.

10. Clear the Automatically manage paging file size for all drives check box, and then select the

Custom size option button.

11. In the Paging file size for each drive group box, specify as follows:

For the Initial size text box, specify a value equal to or greater than the Recommended value

shown in the Total paging file size for all drives area.

For the Maximum size text box, specify a value equal to or greater than the value specified in the

Initial size text box.

After specifying the above values, click [Set].

Note the following when specifying a paging file size.

• The above paging file sizes are recommended for collecting debug information (dump file).

The initial size of the Windows partition paging file must be large enough to store dump files.

Make sure to set a sufficient paging file size. If the paging file size is insufficient, correct

debug information might not be able to be collected due to a shortage of virtual memory.

• For details about the Recommended value in the Total paging file size for all drives area,

refer to System partition size in Before Starting Setup.

• When memory is added, re-specify the paging file according to the increased memory size.

12. Click [OK].

The message to restart the system appears depending on the modifications made.

In this case, restart the system.

Specification of the memory dump settings is now complete.

1 2 ... 244 245 246 247 248 249 250 251 252 253 254 ... 274 275

Sin comentarios

NEC Express5800/GT110e-S Guía de instalación Pagina 249