NEC GammaCompMD QA Manual de usuario descargar pdf (Pagina 80)

GammaCompMD QA Client User Manual

External Sensor Selection

The external sensor can be selected from the External Sensor

Selection listbox, as shown in Figure 56.

NOTE: Only one external sensor is supported at time and it will be the last selected sensor

model.

Figure 56: External Sensor Selection Listbox

Auto-Detect button Clicking on this button allows the external sensor to be

automatically detected, even if a sensor was not yet selected from

the External Sensor Selection listbox described above.

OK button Saves the sensor setting to the selected display and closes the

dialog box. The OK button cannot be clicked unless the Operator

Name is entered.

Cancel button Closes the dialog box without applying any changes. However, any

settings that were applied by clicking the Apply button cannot be

returned to its previous state.

Apply button Applies the settings but does not close the dialog box. The Apply

button cannot be clicked unless the Operator Name is entered.

Additional considerations

Using external sensors If a calibration or test is executed, the sensor contact position

guide, as shown in Figure 57, is displayed. Position the sensor on

the display according to the guidance and click the Continue

button at the bottom left of the screen to start the measurement.

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 181 182

Sin comentarios

NEC GammaCompMD QA Manual de usuario Pagina 80