
GammaCompMD QA Client User Manual
Copyright © NEC Display Solutions Ltd., 2006 -2015 164
An “X” appears in Target
Display Setting in the display
information area.
An “X” appears next to Target Display Setting if
a display is connected with a different display
configuration compared last time, or if the
display is disconnected.
■ If the display has been changed back to the
previous display configuration, click Update
Display Information and check that the “X” has
disappeared.
■ If you wish to apply a new configuration, you
will need to Reinitialize Display Configuration.
Refer to 7.7.1.1 Re-initialization of Display
Configuration (page 105).
A “?” (question mark) appears
next to Target Display Setting in
the display information area.
A “?” appears next to Target Display Setting if
the resolution or coordinates of a display have
changed since the last time, or if the display is
not turned on.
■ If the display has been changed back to the
previous display configuration, click Update
Display Information and check whether the “?”
has disappeared.
■ If you wish to apply a new configuration, you
will need to Reinitialize Display Configuration.
Refer to 7.7.1.1 Re-initialization of Display
Configuration (page 105).
An error dialog appears stating
“Communication with the
system service failed.
The service may not have
been started. An administrator
account for the Operating
System is required to start it
manually. If you want to start
the service, click OK.”
GammaCompMD QA Client cannot startup
because the engine service
(GCMDQAEngineService) is disabled.
Click OK to the error dialog to start the engine
service. Then manually start GammaCompMD
QA Client.
Comentarios a estos manuales