
GammaCompMD QA Client User Manual
Copyright © NEC Display Solutions Ltd., 2006 -2015 23
If the main screen setting is correctly done, Sensor Contact Position Guide (Figure
57) will be shown before calibration or taking other measurements starts. If QA Test
starts, the following message (Figure 5) will be shown before calibration or taking
other measurements starts.
When the circle and the rectangle are displayed correctly related to the center of
screen, the user is allowed to continue the operation.
If the circle and the rectangle are displayed incorrectly, click the cancel button. In this
case, execute 7.7.1.1 Re-initialization of Display Configuration (page 105) after
setting according to the correct example.
Figure 5: Continue Operation dialog
When the main screen setting is not correctly done, the following message (Figure 6)
may be shown. In this case, please check and redo the setting.
Figure 6: Abort Operation dialog
Comentarios a estos manuales