NEC Express5800/R120f-1M Guía de usuario descargar pdf (Pagina 72)

raidcmd

Step 1 Connect Physical Devices used for Easy

Configuration to the RAID Controller before executing

raidcmd if required.

Step 2 Execute "

econfig

" command.

Step 3 Specify the conditions on Easy

Configuration.

In step 1/3, select the RAID Controller to be

configured. Enter the RAID Controller number to be

configured.

Step 4 In step 2/3, specify the number of

Physical Devices used for Logical Drive(s) ("Physical

Device count using Logical Drive(s)") and the number

of Logical Drives to be created in the RAID Controller

("Making Logical Drive count"). If Physical Devices of

different Interface Types, Device Type or Sector

Format exist, specify the number of Physical Devices

in each type (in the example shown to the right,

proper settings are provided for Physical Devices of

the SAS interface. If other Physical Devices of

different types exist, perform the operation in each

type).

Step 5 Step 3/3 shows the configuration of the

RAID System to be configured by the Easy

Configuration. To configure the RAID System

according to the displayed information, type "yes". To

change the configuration, type "no".

If you type "yes", the raidcmd executes the

configuration of the RAID System. After the easy

configuration is finished successfully, raidcmd

terminates normally. Making Logical Drives and Hot

Spares is now completed. See the property of each

component to check the configuration. However, the

Initialize of the Logical Drives having been created

may not be completed. The progress of initializing the

Logical Drives can be checked by using "

oplist

command. The result of initializing the Logical Drive

can be checked by RAID Log.

> raidcmd econfig

Step 1/3 : Select RAID Controller

RAID Controller #1 LSI MegaRAID SAS 9267-8i

RAID Controller [1] :1

Step 2/3 : Set the contents of configuration

Unused Physical Device count : 4

Physical Device count using Logical Drive(s) [ 2- 4] : 3

Hot Spare count : 1