
SUSE Linux Enterprise Server 11 SP2 or later
(Note1) This is required when you use ExpressUpdate.
2) This is required when you use N8103-109/128/134/135 RAID Controllers.
Install these packages by the following procedure (This procedure is an example using standard C++ library).
You can check by rpm command if standard C++
library exists in the computer or not. If it has existed in
your computer, rpm command appears as shown in the
right (the part "*" depends on the operating system). In
this case, go to the section "Installation (Linux, VMware
ESX)".
If standard C++ library has not existed in your
computer, rpm command appears as shown in the right.
In this case, install it to your computer.
Insert the install disk of operating system that includes
the "standard C++ library" to CD-ROM/DVD-ROM drive of
your computer.
Change the current directory to the directory where
standard C++ library exists and install the standard C++
library by rpm command (the part "*" depends on the
operating system).
You can see the result of installation by rpm command.
After the installation finishes, the following package will exist in your computer.
libstdc++*
(The part "*" depends on the operating system.)
If the installation fails, the package will not exist in your computer.
standard C library glibc
GCC library li/jointfilesconvert/31597/bgcc
cron cron
syslog-ng syslog-ng (*)
klogd (*)
libnet (*)
others pciutils
iptables
psmisc (Note2)
> rpm -q libstdc++
libstdc++*
>
> rpm –q libstdc++
package libstdc++ is not installed
> rpm –ivh libstdc++*.rpm
Preparing... ##############################
[100%]
1:libstdc++ ############################## [100%]
> rpm -q libstdc++
libstdc++*
>
26
Comentarios a estos manuales