NEC Express5800/R110f-1E Guia de preparacion descargar pdf (Pagina 92)

NEC ESMPRO Manager Setup Guide

Protocol

Port Number Enter port number where WS-Man service listens for connection. *3

RAID system management

Management Select "Registration" to manage the RAID system of the component.

If the operating system of the managed component is VMware ESXi5,

WS-Man management must be enabled in addition to this setting.

NEC ExpressUpdate

Updates via NEC

ExpressUpdate Agent

Select "Registration" to manage the component using NEC

ExpressUpdate.

Updates via

Management Controller

Select "Registration" to manage the component using Management

Controller

BMC (EXPRESSSCOPE Engine)/ vPro (Common)

Management Select "Registration" otherwise NEC ESMPRO Manager may not monitor

HW status.

Management Type Select "vPro".

User Name Enter the user name for communication with the vPro,

Password Enter the password for communication with the vPro,

BMC (EXPRESSSCOPE Engine)/ vPro (LAN)

IP Address 1 Enter the IP address that is specified on LAN of the iAMT configuration

for the managed component.

Subnet Mask1 Enter the subnet mask that is specified on LAN of the iAMT configuration

for the managed component.

CHECK:

・*1 If NEC ESMPRO Manager is installed on Linux system, “SNMP” is not supported.

CHECK:

・*2 If a self signed certificate is installed on the managed server for HTTPS

communication, a setting to allow it is required. Refer to “1.1 Setup Flow” for

detailed information.

CHECK:

・*3 Regarding a port number for WS-Man communication, refer to “Appendix C. Port

number for WS-Man communication”.

(4) Click "Add".

(5)Click the "Connection Setting" from "Setting" tab of the managed component.

Click "Check Connection" to collect the managed component information for the management.

When the "Check Connection" is completed, the NEC ESMPRO Manager starts to control the managed

component.

Detected Detail

Detected The feature was detected.

NEC ESMPRO Manager can use the feature to manage the component.

Not Detected The feature was not detected.

NEC ESMPRO Manager cannot use the feature to manage the component.

Check parameters corresponding to the feature.

1 2 ... 87 88 89 90 91 92 93 94 95 96 97 ... 124 125

Comentarios a estos manuales

Sin comentarios

NEC Express5800/R110f-1E Guia de preparacion Pagina 92

Comentarios a estos manuales

Relacionado con productos y manuales para Gateways / Controladores NEC Express5800/R110f-1E