NEC Express5800/R110f-1E Guia de preparacion descargar pdf (Pagina 54)

NEC ESMPRO Manager Setup Guide

Select "LAN" tab page for LAN port 1 of the BMC.

Set the below items. The other items can be used with the default values.

-- "Obtain an IP Address automatically (DHCP)"

Determine whether to dynamically obtain an IP address from a DHCP server.

If the item is set enable and registered, the BMC set the value obtained from DHCP server on "IP

Address", "Subnet Mask" and "Default Gateway".

You can set enable on the item only if the BMC supports this capability.

-- "IP Address"

Case that BMC on the managed component uses Management LAN port; enter the IP address for the

Management LAN port.

Case that BMC on the managed component uses a standard LAN port: be sure to make the setting

identical to the setting on the operating system of the managed component.

-- "Subnet Mask"

Enter the subnet mask for the IP address.

-- "Default Gateway"

Enter the default gateway if the managed component connects to the management PC via any

gateway,

-- "Alert Receiver / Management PC IP Address" – "Primary"

Enter the IP address of the management PC.

The following screen shows example.

CHECK:

・To communicate with the NEC ESMPRO Manager via LAN2, make the setting on the

"LAN2" tab as same as "LAN" tab. If the BMC of the managed component does

not support communication via LAN2, the values of "LAN2" tab page have no

effect with the managed component.

The managed component installed the BMC that uses Management LAN port

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 124 125

Sin comentarios

NEC Express5800/R110f-1E Guia de preparacion Pagina 54