NEC Express5800/R110f-1E Guia de preparacion descargar pdf (Pagina 56)

NEC ESMPRO Manager Setup Guide

2.2.2.2 Run NEC EXPRESSBUILDER DOS based with remote console feature

If you set "Default Gateway" at creating the configuration information file, please connect the managed

component via LAN port used by BMC and the gateway to network.

If you set "Alert Receiver / Management PC IP Address" on same network with the managed

component at creating the configuration information file, please connect the managed component via

LAN port used by BMC and the alert receiver/management PC to network.

Configure the BMC of the managed component with the configuration information.

Insert the NEC EXPRESSBUILDER CD-ROM into the CD-ROM drive and the "configuration

information FD" into the FD drive on the managed component. And then turn on the component.

After NEC EXPRESSBUILDER DOS based with remote console feature is started and the

configuration information is loaded from the FD into the managed component. The MAC addresses of

the gateway and the alert receivers will be also set in the BMC. And then the Operating System will be

rebooted.

TIPS:

・If the setting in the configuration information file is already configured, the managed

component will be not rebooted.

When the console-less function for LAN connection is used, the BIOS settings are

changed as follows:

Serial Port Address: On Board COM B (only for the managed server

supporting SOL)

Baud Rate: 19.2kbps (only for the managed server supporting SOL)

Flow Control : RTS/CTS for the managed server supporting SOL

No Flow for the managed server not supporting SOL

Terminal Type (Console Type) : PC-ANSI (only for the managed server

supporting SOL)

To check whether that the managed component supports SOL, see Appendix C.

Managed Components Summary.

The managed component is opened the main menu of the NEC

EXPRESSBUILDER after executing the feature.

After registering the managed component on the NEC ESMPRO Manager and

confirm the remote console for the managed component, remove the NEC

EXPRESSBUILDER from the CD-ROM drive if you need.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 124 125

Sin comentarios

NEC Express5800/R110f-1E Guia de preparacion Pagina 56