NEC Express5800/R110f-1E Guia de preparacion descargar pdf (Pagina 90)

NEC ESMPRO Manager Setup Guide

Chapter6 Setup for the Managed Component based on

vPro

6.1 Setup Flow

Setup by the following setup procedures:

Connect the management PC on which NEC ESMPRO Manager is installed and the managed

component based on vPro on the same network.

Configure iAMT on the managed component based on vPro.

6.2 Configure iAMT on the Managed Component

Turn the managed component on.

Press <Ctrl+P> immediately after the component based on vPro displays the message prompting you to press

the key.

Main menu of the iAMT configuration is displayed.

Please enter the password to configure the iAMT.

TIPS:

・The NEC ESMPRO Manager can manage the vPro including the iAMT firmware version 6.0 and later.

・The default user name and password are both "admin".

・The iAMT configuration method may depend on the iAMT firmware version.

Refer to the website for detail configuration information and configure iAMT.

The following is an example of the website.

Please note that this URL is subject to change without notice.

http://software.intel.com/en-us/articles/intel-active-management-technology-intel-amt-software-develop

ment-kit-sdk-start-here-guide/

"Performing Manual Setup (from Release 6.0)" or "Manually Configuring an Intel AMT 7.0" of

"AMT7.0 Start Here Guide"

6.3 Register the managed component on NEC ESMPRO

Manager

6.3.1 Add Group to which the managed component will belong

See 1.3.2"1.3.2 Add Group to which the managed component will belong".

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 124 125

Sin comentarios

NEC Express5800/R110f-1E Guia de preparacion Pagina 90