NEC Express5800/R110f-1E Guia de preparacion descargar pdf (Pagina 29)

NEC ESMPRO Manager Setup Guide

If the managed component is a server which has EXPRESSSCOPE

Engine SP3(2BMC model), you should enter the IP address of the

management LAN port for the Standby BMC to the form.

Subnet Mask1 Enter the subnet mask that is specified on LAN2 of the BMC

configuration for the managed component.

If the managed component is a fault tolerant server, you should enter the

subnet mask of the management LAN port for the CPU/IO module 1 to

the form.

If the managed component is a server which has EXPRESSSCOPE

Engine SP3(2BMC model), you should enter the subnet mask of the

management LAN port for the Standby BMC to the form.

CHECK:

・*1 If NEC ESMPRO Manager is installed on Linux system, “SNMP” is not supported.

CHECK:

・*2 If a self-signed certificate is installed on the managed server for HTTPS

communication, a setting to allow it is required. Refer to “1.1 Setup Flow” for

detailed information.

CHECK:

・*3 Regarding a port number for WS-Man communication, refer to “Appendix C. Port

number for WS-Man communication”.

IMPORTANT:

・If BMC(EXPRESSSCOPE Engine) management is disabled, NEC ESMPRO Manager

may not be able to monitor HW status. Detailed information is shown in the

connection check result screen.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 124 125

Sin comentarios

NEC Express5800/R110f-1E Guia de preparacion Pagina 29