NEC Express5800/R110f-1E Guia de preparacion descargar pdf (Pagina 21)

NEC ESMPRO Manager Setup Guide

CHECK:

・If a managed component supports SOL and "Redirection" is selected to "Enable", you

must change the following items necessary for the remote console via the LAN.

Input <F2> key on the POST screen of the managed component.

"SETUP" page – "Advanced" page – "Serial Port Configuration" page – "Flow

Control": Hardware RTS/CTS.

Select "OK".

The configuration information is set in the BMC.

Select network configuration screen.

・In the case of BMC Configuration: “BMC Configuration”  “Network”  “Property”

・In the case of Server Configuration Utility: “EXPRESSSCOPE Engine 3”  “Configuration” 

“Network”  “IPv4 Property”

CHECK:

・If you configure a fault tolerant server, there are the menu ”Network: CPU/IO module

0” and the menu “Network 1: CPU/IO module 1”. Please configure both CPU/IO

modules.

Set the following items. The other items can be used with the default values.

-- "DHCP"

Determine whether to dynamically obtain an IP address from a DHCP server.

If the item is set Enable and applied, BMC set the value obtained from DHCP server on "IP Address",

"Subnet Mask" and "Default Gateway".

-- "IP Address"

Enter the BMC IP address.

-- "Subnet Mask"

Enter the subnet mask for the IP address.

-- "Default Gateway"

Enter the default gateway if the managed component connects to management PC via any gateway.

The following screen shows example.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 124 125

Sin comentarios

NEC Express5800/R110f-1E Guia de preparacion Pagina 21