NEC Express5800/R110f-1E Guia de preparacion descargar pdf (Pagina 79)

NEC ESMPRO Manager Setup Guide

3.2.2 Configuration with NEC EXPRESSBUILDER DOS based with remote

console feature (for modem/direct connection)

NEC EXPRESSBUILDER DOS based with remote console feature can configure the BMC on the managed

component with the configuration information FD containing the configuration information. This section

explains for direct connection.

CHECK:

・Configuration with NEC EXPRESSBUILDER DOS based with remote console

feature can be available only from the NEC EXPRESSBUILDER that contains

NEC ESMPRO Manager.

See the user's guide provided with the managed component about NEC

EXPRESSBUILDER DOS based with remote console feature.

If there is the description about NEC EXPRESSBUILDER DOS based with remote

console feature, the feature is available.

Perform the following procedure:

(1) Creates a configuration information file

(2) Run NEC EXPRESSBUILDER DOS based with remote console feature

3.2.2.1 Creates a configuration information file

Start the NEC ESMPRO BMC configuration installed on any PC to create the configuration information

file.

Click "New". The confirming message will be displayed. Click "OK".

The "BMC Configuration" dialog box will appear.

Click "Common" tab page.

Be sure to set the below item. The other items can be used with the default values.

-- "Computer Name"

Enter a unique name for each managed component.

-- "Authentication Key"

-- Set "Remote Control (WAN/Direct)" and "Redirection (WAN/Direct)" to enable.

Select "WAN/Direct" tab page.

Be sure to set the below items. The other items can be used with the default values.

-- "Serial Port Mode"

Select "Direct" for direct connection.

Select "WAN (modem)" for modem connection.

-- "Flow Control"

Select "RTS/CTS"

Insert a formatted floppy disk into the FD drive, and click "OK". A dialog box will appear for specifying

a location where the configuration information is to be saved.

Specify the floppy disk's root directory as the location.

Enter "CSL_LESS.CFG" for the file name, and click "OK".

The configuration information file will be saved on the floppy disk. This floppy disk is called a

"configuration information FD".

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 124 125

Sin comentarios

NEC Express5800/R110f-1E Guia de preparacion Pagina 79