NEC Express5800/R110f-1E Guia de preparacion descargar pdf (Pagina 15)

NEC ESMPRO Manager Setup Guide

Select Network configuration screen.

・In the case of BMC Configuration: “Set BMC Configuration”  “Network”

・In the case of Server Configuration Utility: “EXPRESSSCOPE Engine 3”  “Network” 

“Property”

CHECK:

・If you configure a fault tolerant server, there are the tab ”Network 0” (for CPU/IO

module 0) and the tab “Network 1” (for CPU/IO module 1). Please configure both

CPU/IO modules.

Set the following items. The other items can be used with the default values.

-- "DHCP"

Determine whether to dynamically obtain an IP address from a DHCP server.

If the item is set Enable and applied, BMC set the value obtained from DHCP server on "IP Address",

"Subnet Mask" and "Default Gateway".

-- "IP Address"

Enter the BMC IP address.

-- "Subnet Mask"

Enter the subnet mask for the IP address.

-- "Default Gateway"

Enter the default gateway if the managed component connects to management PC via any gateway.

The following screen shows example.

If you set "Default Gateway", confirm that the gateway is connected to network.

Click "Apply".

The configuration information is set in the BMC.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 124 125

Sin comentarios

NEC Express5800/R110f-1E Guia de preparacion Pagina 15