NEC Express5800/R110d-1E Guía de usuario descargar pdf (Pagina 84)

Checking Location of Physical Device

The locate function can be used when you want to know the slot to which a specific Physical Device appearing in

the RAID Viewer is inserted in the computer or enclosure. In actual, locate turns on the DISK lamp on the

computer or enclosure in which the specified Physical Device is installed. (The DISK lamp blinks depending on

the types of the computer or enclosures.) Searching for the Physical Device with the DISK lamp being ON allows

the Physical Device for which "check location" is executed on the RAID Viewer and raidcmd to be identified.

The DISK lamp automatically is turned off in 3 minutes. Also, the RAID Controller may have the Turn off function

according to the kind of RAID Controller.

RAID Viewer and raidcmd do not support the indication of the status (ON or OFF) of DISK

lamp. Therefore, you can't recognize the location of the Physical Device when you turn ON the

lamp of two or more Physical Devices at same time. You should turn ON the lamp of Physical

Device one by one. It is convenient when you put down the number of the Physical Device

which turned on a DISK lamp because you can confirm the number of the Physical Device

when turn off the DISK lamp.

Procedure of Checking Location of Physical Device

Locate is executed for a Physical Device. The locate procedure is described below.

RAID Viewer

Use [Locate(Lamp)] in [Control] menu.

Step 1

Start the RAID Viewer. Click a Physical Device to

be located on the tree view, select [Locate (Lamp)] on the

pull-down menu of menu item [Control], and click [ON]. Then

the DISK lamp on the Physical Device goes on (or blinks

depending on the type of the computer). The DISK lamp

automatically is turned off in 3 minutes.

Step 2 In case of the RAID Controller with Turn off function, [OFF] of [Locate(Lamp)] in the [Control] menu becomes

enable. To turn off the DISK lamp, click a Physical Device to be located on the Tree View, select [Locate (Lamp)] on the

pull-down menu of menu item [Control] and click [OFF].

raidcmd

Use "slotlamp" command.

Step 1 To turn on the DISK lamp for locate,

execute "

slotlamp" command with the -sw option set

to "on" using the following parameters.

-c : Number of the RAID Controller containing the Physical

Device for which its location is checked

-p : Number of the Physical Device for which its location is checked

-sw : Specify "on" to turn on the DISK lamp

Step 2 To turn off the lighting DISK lamp, execute "slotlamp" command with the -sw option set to "off".

If the RAID Controller does not support the "turning off the Disk lamp" function, the message indicating that it does not

support the function is displayed and raidcmd is finished.

-c : Number of the RAID Controller containing the Physical Device for which its location is checked

-p : Number of the Physical Device for which its location is checked

-sw : Specify "off" to turn off the DISK lamp

> raidcmd slotlamp -c=1 -p=3 -sw=on

> raidcmd slotlamp -c=1 -p=3 -sw=off

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 105 106

Comentarios a estos manuales

Sin comentarios

NEC Express5800/R110d-1E Guía de usuario Pagina 84

Comentarios a estos manuales

Relacionado con productos y manuales para Los controladores raid NEC Express5800/R110d-1E