NEC Express5800/R110d-1E Guía de usuario descargar pdf (Pagina 105)

105

Installation / Uninstallation

DistributedCOM event is registered during installing or

uninstalling

The following events might be registered in the event log of OS during installation or uninstallation of Universal

RAID Utility under Windows Server 2008 R2 or Windows 7. Even if the following events are registered, there is no

problem in the operation of the system and Universal RAID Utility.

Source

Event ID

Description

DistributedCOM 10001 Unable to start a DCOM Server:

{E9513610-F218-4DDA-B954-2C7E6BA7CABB} as /.

RAID Viewer, Log Viewer

Verification of Authenticode signature at the startup of the

RAID Viewer and Log Viewer

RAID Viewer and Log Viewer have an Authenticode signature. When you start the Microsoft .NET Framework

Version 2.0 managed application that has an Authenticode signature, .NET Framework Version 2.0 verify the

validation of Authenticode signature. Therefore if you use the computer not connected network and the computer

connected bad quality network, may wait a few minutes until startup the RAID Viewer and Log Viewer.

Information

http://support.microsoft.com/kb/936707/en

About the startup without Microsoft .NET Framework Ver2.0

or later

RAID Viewer and Log Viewer will fail to start if you do not install Microsoft .NET Framework Version 2.0 or later in

advance.

1. When the version that is older than Microsoft .NET Framework Version 2.0 exists

The message dialog to show the occurrence of the initialization error of .NET Framework is displayed.

2. When .NET Framework does not exist

The message dialog to show the occurrence of the application error which generated by the link error of .NET

Framework is displayed.

And, the following events are registered in the event log of OS.

Source

Event ID

Description

Application Popup 26 Application popup: raidview.exe(or rlogview.exe) – Application Error : The

application failed to initialize properly (0xc0000135). Click on OK to

terminate the application.

You must install Microsoft .NET Framework Version 2.0 or higher to use the RAID Viewer and Log Viewer.

1 2 ... 100 101 102 103 104 105 106

Sin comentarios

NEC Express5800/R110d-1E Guía de usuario Pagina 105