NEC Express5800/R120d-2M Guía de instalación descargar pdf (Pagina 268)

7. Setup for Solving Problems

Express5800/R120d-1M, R120d-2M Installation Guide (Windows)

268

Chapter 1 Installing Windows

9. In the Paging file size for each drive group box, specify as follows:

For the Initial size text box, specify a value equal to or greater than the Recommended value shown in

the Total paging file size for all drives area.

For the Maximum size text box, specify a value equal to or greater than the value specified in the Initial

size text box.

After specifying the above values, click [Set].

Note the following when specifying a paging file size.

• The above paging file sizes are recommended for collecting debug information (dump file).

The initial size of the boot volume paging file must be large enough to store dump files.

Make sure to set a sufficient paging file size. If the paging file size is insufficient, correct

debug information might not be able to be collected due to a shortage of virtual memory.

• For details about the Recommended value in the Total paging file size for all drives area,

refer to System partition size in Before Starting Setup.

• When memory is added, re-specify the paging file according to the increased memory size.

10. Click [OK].

A message to restart the system might appear, depending on the modifications made.

In this case, restart the system.

Specification of the memory dump settings is now complete.

1 2 ... 263 264 265 266 267 268 269 270 271 272 273 ... 290 291

Sin comentarios

NEC Express5800/R120d-2M Guía de instalación Pagina 268