NEC Express5800/R120d-2M Guía de instalación descargar pdf (Pagina 166)

5. Setting Up Windows Server 2003 R2 x64 Edition

Express5800/R120d-1M, R120d-2M Installation Guide (Windows)

166

Chapter 1 Installing Windows

20. If a RAID Controller or optional SCSI Controller is used, press <F6> key while either of the following

messages is displayed. If not, go to step 27 without pressing <F6> key.

"Setup is inspecting your computer's hardware configuration" (on the top of the screen)

"Press F6 if you need to install a third party SCSI or RAID driver…" (on the bottom of the screen)

Tips

• Note that nothing changes on the screen even when <F6> key is pressed.

• If the OEM drivers list is not displayed at step 22,24 or 26, check the boot order

of the Flash FDD on BIOS settings.

21. The following message appears.

If N8103-149/150/151 RAID Controller is connected, press <S> key and go to step 22.

If not, go to step 23.

22. Select the following from the driver list, and then press <Enter> key.

LSI MegaRAID SAS RAID Controller Driver

The screen shown in step 21 appears. Go to step 23.

23. If N8103-107 is connected, press <S> key and go to step 24. If not, go to step 25.

24. Select Adaptec Ultra320 SCSI Cards (Windows 64-bit), and then press <Enter> key.

Note

If the following message appears, press <S> key to proceed.

The screen shown in step 21 appears again. Go to step 25.

25. If N8103-104A is connected, press <S> key and go to step 26.

If not, press <Enter> key and go to step 27.

The driver you provided seems to be newer than the Windows

default driver.

Windows already has a driver that you can use for “Adaptec

Ultra 320 SCSI Cards (Windows 64-bit)”

Unless the device manufacturer prefers that you use the

driver on the floppy disk, you should use the driver in

Windows.

1 2 ... 161 162 163 164 165 166 167 168 169 170 171 ... 290 291

Sin comentarios

NEC Express5800/R120d-2M Guía de instalación Pagina 166