
3. Setting Up Windows Server 2008 R2
Express5800/R120d-1M, R120d-2M Installation Guide (Windows)
Chapter 1 Installing Windows
3.
Setting Up Windows Server 2008 R2
Set up Windows Server 2008 R2.
3.1
Before Starting Setup
Read through the cautions explained here before starting setup.
: Setting up of Pre-installed model
: Confirm during Setup with EXPRESSBUILDER
: Confirm during Setup with OS standard installer
(1/4)
Setup Items to confirm
Windows
family
The following editions of the Windows Server 2008 R2 family may be installed.
• Windows Server 2008 R2 Standard
• Windows Server 2008 R2 Enterprise
Inquiries about installing other editions may be made at your sales representative.
For information about Service Packs, refer to Chapter 1 (1.2
Support).
Hardware
configuration
The following hardware configurations require special procedures.
―
•
Reinstalling to a mirrored volume
Disable the mirroring and reset to the basic disk. After installation, enable the
mirroring again.
Use [Computer Management] –
[Disk Management] to create, disable, or
remove the mirrored volume.
―
•
Peripheral devices such as RDX/MO
Remove an MO device before installing an OS. Some peripheral devices need
to be halted before installation. Refer to the manual provided with the peripheral
devices for how to set a device appropriate to installation.
―
•
DAT, LTO, and similar media
Do not set media that is unnecessary to installation during setup.
―
•
Reinstalling to hard disk drives that have been upgraded to dynamic disks
If the hard disk drive has been upgraded to a dynamic disk, the operating system
cannot be reinstalled to it with the existing partitions.
Set up the operating system with the OS standard installer.
―
•
Connecting to multiple hard disk drives (logical drives)
For details on installing operating systems to a system in which multiple logical
drives exist, refer to Chapter 1 (3.8 I
nstallation When Multiple Logical Drives
Exist).
Comentarios a estos manuales