NEC Express5800/R120d-2M Guía de instalación descargar pdf (Pagina 154)

5. Setting Up Windows Server 2003 R2 x64 Edition

Express5800/R120d-1M, R120d-2M Installation Guide (Windows)

154

Chapter 1 Installing Windows

(2/3)

Setup Items to confirm

−

Hardware

configuration

• Notes on using N8103-149/150/151 on Windows2003:

1) When a battery is used:

The following message may appear on POST screen at reboot if Service

Pack2 is not yet applied. It is not the problem.

cache data recovered successfully

2) When no battery is used:

Set the cache mode of RAID Controller to the default setting (AutoSwitch

or WriteThrough) until Service Pack 2 is applied.

- To operate the RAID Controller in WriteBack mode, change

setting to

WriteBack after Service Pack 2 is applied.

* The default cache mode of RAID Controller is AutoSwitch

. It will not

change to WriteBack mode unless it is changed manually at or after

creation of VD.

−

•

Connecting MO devices

Installing Windows

while an MO device is connected can result in installation

failure. Remove the MO device, and then start installation from the beginning.

−

•

DAT, LTO, and similar media

Do not set media that is unnecessary to installation during setup.

−

• Connecting to multiple hard disk drives (Logical Drives)

For details on installing operating systems to a system in which multiple Logical

Drives exist, refer to Chapter 1 (5.7 Installation When Multiple Logical Drives

Exist).

−

•

Reinstallation to a dynamic disk:

When installing the OS on a hard disk d

rive with multiple partitions that was

upgraded to a dynamic drive and you wish to retain the existing partition

configuration and data areas, note the following:

Normal (system)

Normal

Data area

(partition to be retained)

- Select the partition on which the OS was previously installed.

- Select Leave the current file system intact (no change)

for the OS partition

format.

−

Service Pack

Before applying a Service Pack, make sure that Windows Server 2003 R2 Edition

DISC 2 has been installed.

−

Use Starter Pack when you apply a Service Pack

from the Service Pack 2

CD-ROM.

−

If you used OS installation media

including Service Pack 2 for installation, you do

not have to install Service Pack 2 again.

1 2 ... 149 150 151 152 153 154 155 156 157 158 159 ... 290 291

Comentarios a estos manuales

Sin comentarios

NEC Express5800/R120d-2M Guía de instalación Pagina 154

Comentarios a estos manuales

Relacionado con productos y manuales para Software NEC Express5800/R120d-2M