NEC Express5800/R120d-2M Guía de instalación descargar pdf (Pagina 227)

6. Setting Up Windows Server 2003

Express5800/R120d-1M, R120d-2M Installation Guide (Windows)

227

Chapter 1 Installing Windows

When the following message appears, set OS installation media, and click [OK].

18. The server automatically restarts.

To use OEM driver, change boot priority of Flash FDD on BIOS settings, after restarting the server.

Select Boot, Floppy Drive BBS priorities, Boot Option #1, and then specify the Flash FDD used.

19. Run from the OS installation media.

If a bootable operating system is already installed on the hard disk drive, press <Enter> key while the

message "Press any key to boot from CD or DVD…" is displayed on the top of the screen.

The boot sequence proceeds and the following message appears.

Note

If this message does not appear, reboot the server and retry.

This step is unnecessary if no bootable operating system exists.

20. If a RAID Controller or optional SCSI Controller is used, press <F6> key while either of the following

messages is displayed. If not, go to step27 without pressing <F6> key.

"Setup is inspecting your computer's hardware configuration" (on the top of the screen)

"Press F6 if you need to install a third party SCSI or RAID driver…" (on the bottom of the screen)

Tips

• Note that nothing changes on the screen even when the <F6> key is pressed.

• If the OEM drivers list is not displayed at step 22, 24 or 26, check the boot order

of the Flash FDD on BIOS settings.

1 2 ... 222 223 224 225 226 227 228 229 230 231 232 ... 290 291

Sin comentarios

NEC Express5800/R120d-2M Guía de instalación Pagina 227