NEC Express5800/R120d-2M Guía de instalación descargar pdf (Pagina 130)

4. Setting Up Windows Server 2008

Express5800/R120d-1M, R120d-2M Installation Guide (Windows)

130

Chapter 1 Installing Windows

4.5.2

Setting up LAN drivers

(1) Setting link speed

The transfer rate and duplex mode of the network adapter must be the same as those of the switching hub.

Follow the procedure below to specify the transfer rate and duplex mode.

1. Open the Device Manager.

2. Expand Network Adapters, and then double-click the name of the network adapter you want to set.

The properties of the network adapter will be displayed.

3. Select the Advanced tab, and then set the Speed & Duplex values to the same as those of the switching

hub.

4. Click [OK] in the Network Adapter Properties dialog box.

5. Restart the system.

The link speed setting is now complete. Proceed to set up WOL.

(2) Setting the iSCSI Offload Engine (if using N8104-128)

If using N8104-128 with the server, iSCSI Offload Engine must be set to off.

Follow the procedure below to set it.

1. Double-click the Broadcom Control Suite3 icon on the Control Panel window.

Broadcom Advanced Control Suite3 starts.

2. Select Device Management under Explorer View, and then N8104-128 network adapter from System

device (VBD).

3. Select the Configurations tab, and then expand Resource Reservations.

4. Remove a checkmark from [iSCSI Offload Engine] under [Pre-Allocated Resource], if checked. Then,

click [Apply].

5. Complete steps 2 to 4 for each N8104-128 network adapter.

6. Restart the system.

iSCSI Offload Engine setup is now complete.

Important

Pleas refer “N8104-128 LAN Driver Installation Guide” that is attached to the

LAN boards to configure N8104-128.

1 2 ... 125 126 127 128 129 130 131 132 133 134 135 ... 290 291

Sin comentarios

NEC Express5800/R120d-2M Guía de instalación Pagina 130