NEC SigmaBlade AD106a Guía de usuario descargar pdf (Pagina 71)

Configuring Your Storage and I/O Blade 4-27

Virtual Drives

When you click [Virtual Drives] on WebBIOS Top Menu, the screen for operating the VD that has

already been configured. List of VDs box shows existing VDs.

Fast Initialize

Clears the top area of the VD being selected in List of VDs box.

Slow Initialize

Clears whole area of the VD being selected in List of VDs box.

Check Consistency

Checks consistency in the whole area of the VD being selected in List of

VDs box.

If inconsistency is found, correct it.

Properties

Displays the properties of the VD being selected in List of VDs box.

Set Boot Drive

(Current =XX)

Default: NONE

Selects a VD to start operating system.

If the system contains several VDs and you want to start the operating

system from the VD other than VD0, you need to specify the boot drive

manually as shown below. Use the default setting in any other cases.

[Setting procedure]

1. Select a VD you want to start operating system from the List of VDs box.

2. Put a checkmark on "Set Boot Drive (Current =XX)".

3. Click [Go].

IMPORTANT:

 If no virtual drive exists, the List of VDs box will be blank. Use this

menu only when a virtual drive exists.

 Even the "Set Boot Drive" is properly specified, the operating

system may fail to start due to Boot Priority specified in BIOS

SETUP of the CPU blade connected with this Storage and I/O

Blade.

 Inconsistency may be detected at the first Check Consistency

performed after the VD was configured.

List of VDs

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 161 162

Sin comentarios

NEC SigmaBlade AD106a Guía de usuario Pagina 71