NEC SigmaBlade AD106a Guía de usuario descargar pdf (Pagina 31)

General Description 2-9

STATUS Lamp

The STATUS lamp stays lit in green when the Storage and I/O Blade is in successful operation.

When the STATUS lamp is flashing in amber or red, it indicates that the system has failed.

In addition, you can view the detailed information on error message on virtual LCD when the

STATUS lamp is flashing in amber or red. You can use the virtual LCD through the Web console of

Blade Enclosure. See Chapter 8 for indication on virtual LCD, descriptions, and actions to take. If

an error occurs, contact your service representative.

The following tables list indications of the STATUS lamp, descriptions, and actions to take.

NOTE: The Storage and I/O Blade does not support EXPRESSSCOPE

Engine (BMC). You cannot view the error log through NEC ESMPRO

Manager.

STATUS lamp indications

STATUS lamp

Status Color

Description Action

On Green The Storage and I/O Blade

is operating normally.

–

Off –

The power is turned off.

Turn on the power.

On Red BMC is being initialized.

1. Wait until the lamp goes off.

2. If the lamp still goes on, check

installation of the Storage and I/O

Blade.

Flash Red See the table "Virtual LCD indications when STATUS lamp is flashing in

red" described in Chapter 8.

Flash Amber See the table "Virtual LCD indications when STATUS lamp is flashing in

amber" described in Chapter 8.

NOTE: If the Storage and I/O Blade is powered off while the STATUS

lamp is flashing in amber or red, the indication of the STATUS lamp is

retained except for certain factors. When the Storage and I/O Blade is

powered on, the STATUS lamp goes on green (normal status).

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 161 162

Sin comentarios

NEC SigmaBlade AD106a Guía de usuario Pagina 31