NEC SigmaBlade AD106a Guía de usuario descargar pdf (Pagina 150)

9-4 Upgrading Your Storage and I/O Blade

CONFIRMATION AFTER INSTALLATION/REMOVAL

Confirm the following after installing an additional option and removing a component:

 Installing removed components exactly as they were

Install the components and cables, which were removed and disconnected for addition of

an option, exactly as they were. Assembling without a component being installed or a

cable being disconnected causes the Storage and I/O Blade to malfunction.

 Confirming that no parts such as screws are left in the Storage and I/O Blade

Confirm that particularly conductive parts such as screws are not left in the Storage and

I/O Blade. Turning on the power with a conductive part on the mother board or cable

terminal causes the Storage and I/O Blade to malfunction.

 Confirming the cooling effect in the Storage and I/O Blade

Confirm that the ventilating holes are not covered with an internally connected cable.

Insufficient cooling effect raises the internal temperature, which causes the Storage and

I/O Blade to malfunction.

 Confirming operation with a tool

Some additional devices require the diagnostic utility or BIOS SETUP utility to check if

they are installed correctly. For details, see the procedure for additionally installing the

target device.

1 2 ... 145 146 147 148 149 150 151 152 153 154 155 ... 161 162

Sin comentarios

NEC SigmaBlade AD106a Guía de usuario Pagina 150