NEC Display Wall Calibrator Guía de usuario descargar pdf (Pagina 75)

75 | NEC DISPLAY WALL CALIBRATOR - USER’S GUIDE

Chapter

Troubleshooting

Installation and Setup

Problem: Measure and Calibrate buttons are disabled.

Solution: The Measure and Calibrate buttons are disabled for any of the following reasons:

• No supported calibration sensor was detected.

• No supported display monitor was detected.

• All of the displays have not yet been Veried.

Problem: Verify Communications operation fails.

Solution: Check that:

• Each display is correctly congured to use either then LAN or RS232 interface by conrming the

EXTERNAL CONTROL setting on the OSD menu if applicable.

• The MONITOR ID is set correctly on the OSD and matches the value assigned in the software.

If using RS232:

• If using daisy-chaining, conrm that no other displays on the same chain have the same MONITOR ID.

• Make sure that each display is connected via a NULL modem cable and that the correct IN our OUT socket

on the display is used.

• Make sure that no other application or process is using the specied COM port.

If using LAN:

• Make sure that the IP address of each display is set correctly and that each display has a unique IP

address.

• Make sure that the IP address assigned to each display matches those assigned in the software.

• Make sure that no other device on the LAN is assigned the same IP address.

• The IP address of each display must be congured using a web browser. The default IP address is

192.168.0.10.

• Make sure that the displays are on the same subnet as the host PC being used.

• Make sure that there are no rewall settings or antivirus applications that may be preventing the application

from accessing the LAN or blocking port 7142.

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 91 92

Sin comentarios

NEC Display Wall Calibrator Guía de usuario Pagina 75